xTool P2(S)
The workhorse for acrylic, wood and leather.
Stands here and is shown in person.
from €2,999 RRP €4,365 €1,366 off
Price applies to: P2S / Schwarz / xTool P2S Standalone
A good fit when
- You regularly cut acrylic thicker than 3 mm
- Edge quality is a selling point for you
- One machine should cover as many materials as possible
Note What we demonstrate is the identical predecessor P2, which stands in the Hirzenhain workshop. For cut quality, format and handling it is a sound reference, and the differences to the current P2S are marginal. The price quoted is the P2S price.
Key figures
- Laser type
- CO₂
- Power
- 55 W
- Work area
- 60 × 30.8 cm
What it actually takes up
The dimensions are the manufacturer figures. The clearance next to them is not: that is our own estimate from running these machines — room for workpieces beside it, for hose and cable behind it, and for the lid or your hands above it. That is the number no data sheet carries.
- Machine size
- 100 × 63.9 × 26.8 cm
- Footprint in use
- 140 × 89 cm
- Height with the lid open
- 72 cm
- Weight
- 45 kg
- Including extraction
- 1.54 m²
A metre wide, with a lid that swings up. This is where most setups fail: it will sit on an 80 cm table, but you can no longer reach the wall behind it. If you want to feed sheets in from the side, you need clear runway left and right as well. Add extraction, and put 45 kg on a table that can take it.
Current price in the official xTool shop (de.xtool.com), last checked automatically on 29/09/2026, 08:26, including VAT. Each figure is the base configuration without a bundle; options and accessories change it considerably. Only your personal quote is binding.
From our own workshop
The one for thick material: it cuts wood and acrylic at thicknesses where a diode laser gives up. And as a CO₂ source it is the only one we have that can cut transparent and translucent acrylic at all — for anything that has to stay see-through, there is no alternative here.
See it
It stands in Hirzenhain. An appointment lasts one hour and belongs to this one machine — bring your own material.
Everything about the Hirzenhain location Back to all machines All photographs from shop and workshop
Read before you buy
- Geschlossene Lasergravierer (Laserklasse 1): Marktübersicht 2026 Geschlossene Klasse-1-Geräte gibt es 2026 ab 219 €. Marktübersicht mit deutschen Preisen von Creality bis xTool, und was den Aufpreis rechtfertigt.
- Welche xTool-Geräte laufen 2026 noch mit LightBurn, und welche nicht? Firmware-Update, gekappte Verbindungen, xTool Studio statt XCS: die Kompatibilitätsübersicht 2026, inklusive der Geräte, die nie LightBurn sprechen.
From our German knowledge section — these articles are in German only.
Your material. Your machine. One hour.
The demo costs nothing and ends without a signature. It ends with you knowing which machine fits what you are planning and which one you can skip.
Booking runs through the official xTool demo system, opens in a new tab.